Dotco 14-2401 Router Guide For Router Bits with 1/4″ Shank Bit

Built for controlled routing with compatible Dotco routers, the Dotco 14-2401 Router Guide helps support accurate tool movement when using 1/4″ shank router bits. This accessory helps guide the router during trimming, edge-finishing, and material removal work where repeatable control is critical.

The 14-2401 is a router guide accessory only and is not a complete router. It is suited for composite fabrication, aerospace work, woodworking, and general shop routing tasks when paired with the correct Dotco router and compatible 1/4″ shank bit.

Type: Router Guide | Model: 14-2401 | Compatible Bit Shank: 1/4″ | Application: Router Bit Guidance

Important: Insert the bit into the collet as far as possible, then pull out 1/16″ and tighten the collet.

In an emergency: If it is necessary to pull out the bit more than 1/4″, be sure to insert a short length of blank shank (not to exceed 5/8” long) in the bottom of the collet before inserting the bit.

Applications:

• Composite trimming and routing operations.
• Aerospace component edge finishing.
• Woodworking and laminate routing with compatible router bits.
• General fabrication tasks requiring guided router control.

FAQs:

• Q: What bit shank size does the Dotco 14-2401 router guide support?A: This router guide is for router bits with a 1/4″ shank.
• Q: Is the 14-2401 a complete router?A: No. The 14-2401 is a router guide accessory only.
• Q: What is this guide used for?A: It helps guide compatible routing operations for trimming, edge finishing, and controlled material removal.